IDX-3

1. Power up for the first time Plug IDX into a standard 5v USB-C power supply using the rear USB socket.

IDX will glow white, then blue. This indicates it's ready for WiFi setup.

2. Connect to temporary WiFi access point IDX will create a temporary WiFi network for configuration.

On your phone or computer, join the WiFi network named IDX_setup. A window should open automatically. If not, visit http://192.168.4.1 in your browser. Use the password: analoguedeskco

3. Configure WiFi In the IDX WiFi Setup page, once the Wifi Scanning has completed, select your SSID from the list and enter your WiFi password. Click Connect.

Once connected, IDX will glow light blue, and the device's IP address will be displayed.

This address is used to access the IDX Dashboard where you can configure the data source, ambient lighting and other settings.

Copy the address using the COPY button, and press FINISH SETUP.

The page will close as IDX initializes.

4. Access IDX Dashboard Ensure your phone/computer is back on your main WiFi network.

Wait 30 seconds for IDX to complete its initialisation.

Visit the copied IP address in your browser.

Backup Option: If the address is not found, locate IDX's assigned IP address using your router admin page or a network scanner (like Fing). Look for "IDX" or "Espressif". Enter it into a browser address bar.

5. Configure IDX By default, IDX is set to track the current time.

Select MODE to choose what data source IDX should use. Select AMBIENCE to adjust the lighting effect, including night mode.

6. Fit a gauge insert IDX's dial face accepts a swappable, printed insert so the scale matches your chosen MODE.

See the Full IDX-3 Manual below for the included designs and swap instructions.